Owners manual

• 1455 CITRUS ST., P.O. BOX 1329, RIVERSIDE, CA., U.S.A. 92502 • TECH SERVICE 800-858-3333 • FAX [phone]
• e-mail: tech@knlters.com
®
• WWW: http://www.knlters.com
®
INSTALLATION INSTRUCTIONS
Continued
26. Install silicone hose (#08630) onto the air lter
adapter and secure with the provided hose clamp.
27. Install the air lter assembly onto the K&N
®
intake tube and secure with the provided hose
clamp.
28. Re-attach the mass air sensor secondary
connection to the power steering reservoir bracket,
then connect the mass air sensor electrical
connections as shown.
24. Connect the provided crank case vent hose
onto the tting on the valve cover and the vent
tting on the K&N
®
intake tube.
25. Install the air lter adapter into the K&N
®
air
lter and secure the assembly with the provided
hose clamp.
NOTE: Drycharger
®
air lter wrap; part #
RF-1041DK is available to purchase separately.
To learn more about Drycharger
®
lter wraps or
look up color availability please visit
http://www.knlters.com
®
.
18592D
4/30/14
23. Install the K&N
®
intake tube into the silicone
hose at the throttle body and align the intake tube
with the saddle clamp. Secure the intake tube with
the provided hose clamps.
* FREE K&N
®
decal To register your warranty, please see us online at knlters.com/register. FREE K&N
®
decal *
1. Start the engine with the transmission in neutral
or park, and the parking brake engaged. Listen for
air leaks or odd noises. For air leaks secure hoses
and connections. For odd noises, find cause and
repair before proceeding. This kit will function
identically to the factory system except for being
louder and much more responsive.
2. Test drive the vehicle. Listen for odd noises or
rattles and x as necessary.
3. If road test is ne, you can now enjoy the added
power and performance from your kit.
4. K&N Engineering, Inc., requires cleaning the
intake system’s air lter element every 100,000
miles. When used in dusty or off-road
environments, our lters will require cleaning more
often. We recommend that you visually inspect
your lter once every 25,000 miles to determine
if the screen is still visible. When the screen is no
longer visible some place on the lter element, it is
time to clean it. To clean and re-oil, purchase our
lter Recharger
®
service kit, part number 99-5050
or 99-5000 and follow the easy instructions.
ROAD TESTING:
31. It will be necessary for all K&N
®
high ow intake
systems to be checked periodically for realignment,
clearance and tightening of all connections.
Failure to follow the above instructions or proper
maintenance may void warranty.
29. Reconnect the vehicle’s negative battery cable.
Double check to make sure everything is tight and
properly positioned before starting the vehicle.
30. The C.A.R.B. exemption sticker, (attached),
must be visible under the hood so that an
emissions inspector can see it when the vehicle
is required to be tested for emissions. California
requires testing every two years, other states may
vary.