Owners manual

INSTALLATION INSTRUCTIONS
Continued
24. Place the heat shield onto the fender well so
that it will align onto the lower bracket. Secure the
heat shield to the lower bracket with the hardware
provided as shown.
25. Secure the heat shield mounting brackets with
the factory bolts removed in step #20 and #21.
Tighten the mounting brackets to the heat shield.
26. Remove the two screws securing the mass
air sensor to the factory air box. Then remove the
sensor from the air box.
27. Install the provided gasket onto the K&N
®
mass
air sensor adapter as shown.
28. Install the mass air sensor into the K&N
®
adapter and secure with the provided hardware.
29. Install the mass air sensor assembly into the
K&N
®
intake tube.
NOTE: The opening of the mass air sensor
should be towards the lter end of the K&N
®
intake tube.
30. Secure the mass air sensor assembly to the
K&N
®
intake tube with the provided hardware.
31. Install the silicone hose (08630) onto the
throttle body and secure with the provided hose
clamp.
32. Install the K&N
®
intake tube into the silicone
hose at the throttle body and onto the saddle
clamp, then secure with the provided hose clamps.
33. Remove the factory crank case vent hose from
the valve cover.
34. Install the supplied crank case vent hose onto
the valve cover tting and then onto the K&N
®
intake tube as shown.
35. Install the silicone hose (08630) onto the lter
adapter and secure with the provided hose clamp.
36. Install the lter adapter assembly into the K&N
®
lter and secure with the provided hose clamp.
37. Install the lter adapter assembly into the K&N
®
lter and secure with the provided hose clamp.
23. Install the small “L” bracket (010060) onto the
heat shield as shown with the provided hardware.
NOTE: Be sure to place a at washer betweeen
the heat shield and bracket as a spacer. Do not
completely tighten at this time.