Owners manual

INSTALLATION INSTRUCTIONS
Continued
9. Disconnect the TPS sensor electrical connection
from the throttle body.
10. Remove the four throttle body mounting bolts.
NOTE: These bolts will be reused.
11. Lift the throttle body from the intake manifold.
Then disconnect the throttle body motor electrical
connection.
NOTE: Take care to avoid dropping debris
down the intake manifold throat.
12. Using the factory mounting bolts from step
#10, secure the throttle body to the K&N
®
throttle
body adapter with the gasket as shown.
13. Install the throttle body assembly onto the
intake manifold with the provided hardware as
shown.
14. Reconnect the throttle body motor and TPS
sensor electrical connections.
15. Install the provided spacer onto the threaded
stud in the cylinder head.
16. Install the saddle bracket onto the tube
mounting bracket (26633) with the provided
hardware.
17. Install the tube mounting bracket assembly
onto the threaded stud with the spacer installed in
step #15. Then secure with the provided hardware.
18. Install the short edge trim into the hole in the
heat shield as shown.
NOTE: Some trimming of the edge trim may be
necessary.
19. Install the long edge trim around the heat
shield as shown.
NOTE: Some trimming of the edge trim may be
necessary.
20. Remove the anti lock brake mounting bolt
shown.
NOTE: This bolt will be reused.
21. Remove the fresh air intake tube mounting
bracket bolt shown from the radiator core support.
NOTE: This bolt will be reused.
8. Remove the bolt and nut that secure the mount-
ing bracket for the stock fresh air intake tube and
then remove the mounting bracket.
7. Remove the factory air box from the vehicle.
NOTE: K&N Engineering, Inc., recommends
that customers do not discard factory air
intake.
22. Install the large “L” bracket (010060) onto the
heat shield as shown with the provided hardware.
NOTE: Be sure to place a at washer between
the heat shield and bracket as a spacer. Do not
completely tighten at this time.