Owners manual
INSTALLATION INSTRUCTIONS
Continued
10. Pull up rmly on the air box to dislodge it from
the retaining pin, and then remove the air box from
the vehicle.
NOTE: K&N Engineering, Inc., recommends that
customers do not discard factory air intake.
11. Install the provided edge trim onto the heat
shield as shown.
12. Install the heat shield mounting bracket
(010083) onto the heat shield as shown with the
provided hardware.
13. Install the heat shield into the vehicle and
secure the bracket installed in step #12 to the
factory air box mount with the factory bolt removed
in step #9.
14. Install the provided 6mm bolt through the
factory hole in the core support and then install the
provided spacer onto the bolt as shown.
15. Install the provided heat shield bracket
(010084) onto the bolt installed in step #14, and
then fasten the bracket to the heat shield with the
provided hardware.
NOTE: Use the supplied 1/4” washer as a
spacer between the bracket and heat shield.
16. Install the saddle clamp onto the tube-mounting
bracket with the provided hardware as shown.
17. Install the saddle bracket assembly onto the
threaded stud on the engine as shown and secure
with the provided hardware.
18. Install the provided silicone hose (08630) onto
the throttle body and secure with the provided hose
clamp.
19. Using the “TORX” wrench provided, remove the
mass air sensor from the air box lid as shown.
20. Install the provided gasket onto the K&N
®
mass
air adapter as shown.
21. Using the screws removed in step #19, install
the mass air sensor into the K&N
®
mass air
adapter.
22. Install the mass air assembly into the
K&N
®
intake tube and secure with the provided
hardware.
NOTE: Be sure to install with the opening of the
mass air sensor towards the lter end of the
tube as shown.
23. Install the K&N
®
intake tube assembly into
the silicone hose at the throttle body and onto the
saddle clamp and secure with the provided hose
clamp as shown.
24. Pull rmly on the crank case vent elbow to
remove from the vent tube as shown.