Owners manual

INSTALLATION INSTRUCTIONS
Continued
7. Remove the three bolts that secure the air box to
the vehicle then remove air box from vehicle.
NOTE: K&N Engineering, Inc., recommends that
customers do not discard factory air intake.
8. On vehicles that come equipped with A/C,
assemble the saddle bracket onto bracket (07164)
as shown.
8a. On vehicles that do not come equipped with
A/C, assemble the saddle bracket onto bracket
(07165) as shown.
9. On vehicles that come equipped with A/C,
remove the front lower A/C mounting bolt. Then
secure the saddle bracket assemble from step 8
onto vehicle as shown.
NOTE: On 5.0L models use the provided spacer
(07849) under bracket when mounting to
vehicle.
9a. On vehicles that do not come equipped with
A/C, mount the saddle bracket assembly from step
8a onto the idler pully bracket as shown.
NOTE: On 5.0L models use the provided spacer
(07849) under bracket when mounting to
vehicle.
10. Secure the provided silicone hoses (08405)
onto the throttle body with the provided hose
clamps as shown.
11. Install edge trim onto heat shield as shown.
Trim if needed.
12. Remove the mass air sensor from the factory
airbox as shown.
13. Twist the temp sensor counter clock wise to
remove from the facotry airbox.
14. Assemble to mass air sensor to the heat shield
and lter adaptor using the provided gaskets and
hardware as shown.
15. Install the silicone hose (08051) onto the mass
air sensor with the provided hose clamps.
16. Install the new K&N
®
intake tube onto the
throttle body, then secure the intake tube to the
saddle bracket as shown.
17. Install the mass air assembly onto the intake
tube then line up the fresh air duct to the heat
shield and mark the two holes with a marker.
18. Remove the mass air assembly and drill two
1/4” holes were marked in the previous step.
19. Reinstall the mass air assembly and secure
with the provided hose clamps.