Owners manual

* FREE K&N
®
decal To register your warranty, please see us online at knlters.com/register. FREE K&N
®
decal *
INSTALLATION INSTRUCTIONS
Continued
1. Start the engine with the transmission in neutral
or park, and the parking brake engaged. Listen for
air leaks or odd noises. For air leaks secure hoses
and connections. For odd noises, find cause and
repair before proceeding. This kit will function
identically to the factory system except for being
louder and much more responsive.
2. Test drive the vehicle. Listen for odd noises or
rattles and x as necessary.
3. If road test is ne, you can now enjoy the added
power and performance from your kit.
4. K&N Engineering, Inc., requires cleaning the
intake system’s air lter element every 100,000
miles. When used in dusty or off-road
environments, our lters will require cleaning more
often. We recommend that you visually inspect
your lter once every 25,000 miles to determine
if the screen is still visible. When the screen is no
longer visible some place on the lter element, it is
time to clean it. To clean and re-oil, purchase our
lter Recharger
®
service kit, part number 99-5050
or 99-5000 and follow the easy instructions.
ROAD TESTING:
44. It will be necessary for all K&N
®
high ow intake
systems to be checked periodically for realignment,
clearance and tightening of all connections.
Failure to follow the above instructions or proper
maintenance may void warranty.
• 1455 CITRUS ST., P.O. BOX 1329, RIVERSIDE, CA., U.S.A. 92502 • TECH SERVICE 800-858-3333 • FAX [phone]
• e-mail: tech@knlters.com
®
• WWW: http://www.knlters.com
®
43. The C.A.R.B. exemption sticker, (attached),
must be visible under the hood so that an
emissions inspector can see it when the vehicle
is required to be tested for emissions. California
requires testing every two years, other states may
vary.
42. Reconnect the vehicle’s negative battery cable.
Double check to make sure everything is tight and
properly positioned before starting the vehicle.
17013K
4/24/14
28. Lift up on the evaporative canister mounting
bracket and install the heat shield.
28a. On 2004 and later vehicles, lift up the air box-
evap bracket and install the heat shield as shown.
29. Install the provided hardware to retain the heat
shield.
Note: Do not tighten completely at this time.
30. Install the intake tube.
31. Tighten the hose clamp on the hump hose at
the throttle body.
32. Tighten the hose clamp on the stepped hose at
the mass air sensor.
33. Position the heat shield for best alignment and
tighten the hardware that retains it.
34. Tighten the two bolts that retain the evaporative
canister mounting bracket to the inner fender.
35. Attach the idle air control line to the large vent
tting on the intake tube
36. Attach the vent hose provided to the small vent
tting on the intake tube.
37. Connect the PCV line to the vent hose using
the hose mender provided.
38. Reconnect the primary mass air sensor
electrical connection.
39. Reconnect the secondary mass air sensor
electrical connection and reattach the wiring
harness retaining clip to the inner fender apron.
40. On models equipped with an external air
temperature sensor, reconnect the air temperature
sensor electrical connection.
41. Install the Air Filter and tighten the hose clamp.
NOTE: Drycharger
®
air lter wrap; part #
RF-1020DK is available to purchase separately.
To learn more about Drycharger
®
lter wraps or
look up color availability please visit
http://www.knlters.com
®
.