Owners manual

INSTALLATION INSTRUCTIONS
Continued
10. Loosen and remove the three bolts that retain
the air cleaner mounting bracket.
10a. On 2004 and later vehicles loosen and
remove the four bolts, which retain the air box-evap
canister bracket shown.
11. Remove the air cleaner mounting bracket.
NOTE: On 2004 and later vehicles, this bracket
is not removed as it is one piece.
12. Loosen and remove the bolt that retains the
evaporative canister mounting bracket.
13. Loosen the two bolts that retain the evaporative
canister mounting bracket to the inner fender.
14. Remove the two clip nuts from the evaporative
canister bracket lower mounting point.
Note: The clip nuts will not be reused.
14a. On 2004 and later vehicles remove the clip
nuts from under the air box-evap bracket as shown.
15. Disassemble the air cleaner assembly.
16. Using a at blade screwdriver, push in and
release the four clips that retain the mass air
sensor retaining plate.
17. Pull the rubber boot away from the air cleaner.
18. Disconnect the primary mass air sensor
electrical connection.
19. Loosen and remove the bolts that secure the
mass air sensor to it’s retaining plate.
20. Assemble the mass air sensor, heat shield and
adapter using the gaskets and hardware provided.
21. Install the trim seal onto the heat shield as
shown.
22. On models equipped with an external air
temperature sensor, remove the air temperature
sensor from the stock intake tube.
23. On models equipped with an external air
temperature sensor, drill out the drill point in the
K&N
®
intake tube using a 11/16” drill bit.
24. On models equipped with an external air
temperature sensor, insert the grommet into the
hole drilled in the K&N
®
intake tube.
25. On models equipped with an external air
temperature sensor, insert the air temperature
sensor into the grommet.
26. Install the hump hose onto the intake tube and
tighten the hose clamp.
27. Install the stepped hose onto the ange of the
mass air sensor and tighten hose clamp.