Owners manual

INSTALLATION INSTRUCTIONS
Continued
7. Pull the fresh air duct forward to disconnect it
from the airbox and then remove it from the
vehicle.
8. Remove the airbox mounting bolt shown.
9. Lift the lower airbox and remove it from the
vehicle as shown.
NOTE: K&N Engineering, Inc., recommends that
customers do not discard factory air intake.
10. Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim may be
necessary.
11. Install the 1/4”-20 male/female rubber mounted
stud onto the “L” bracket (070952) with the
provided hardware as shown.
12. Install the bracket/rubber mounted stud
assembly onto the heat shield as shown using the
provided hardware.
13. Install the Install the heat shield mounting
bracket and twist bracket onto the heat shield as
shown using the provided hardware.
14. Remove the bolt which secures the vacuum
reservoir to the airbox and then remove the
reservoir from the airbox.
NOTE: Some vehicles may not be equipped
with a vacuum reservoir.
15. Using the provided spacer, install the vacuum
reservoir onto the heat shield as shown.
NOTE: Due to vehicle manufacturing
tolerances, 2 spacers may be required.
NOTE: Some vehicles may not be equipped
with a vacuum reservoir.
16. Remove the coolant reservoir-retaining nut and
airbox mounting grommet shown.
17. Using the two fender washers and one rubber
washer, install the 6mm male/female rubber
mounted stud onto the lower airbox mount as
shown.
18. Install the 6mm male/male rubber mounted
stud onto the upper airbox mount as shown.
19. Install the heat shield assembly into the vehicle
and secure it to the mounting locations with the
provided hardware.
20. Reconnect the vacuum reservoir vacuum line.
20a. Disconnect the air temperature electrical
connection.
20b. Remove the two bolts which secure the intake
plenum to the intake manifold.
NOTE: Some vehicles may have a hose clamp
which secures the intake plenum to the throttle
body which will need to be loosened.
20c. Remove the intake plenum from the vehicle as
shown.
21. Install the silicone hose (08690) onto the
throttle body and secure with the provided hose
clamp.
22. Install the saddle clamp onto the tube mounting
bracket and secure with the provided hardware as
shown.
6. Remove the six grill retaining clips from the grill,
then tilt the grill forward and lift to remove from the
vehicle.