Owners manual
INSTALLATION INSTRUCTIONS
Continued
11. Install the “C” bracket (010123) onto the heat
shield with the provided hardware as shown.
12. Install the provided 5/16” washer onto the
airbox mounting stud as shown.
13. Install the two threaded inserts into the airbox
mounting grommet locations as shown.
14. Install the heat shield assembly and secure
with the provided hardware and the factory airbox
mounting nut.
15. Install the silicone hose (08051) onto the
throttle body and secure with the provided hose
clamp as shown.
16. Twist the air temperature sensor counter
clockwise and remove it from the stock intake
plenum.
NOTE: Take care, as the air temperature sensor
is very fragile.
17. Install the provided grommet into the K&N
®
intake tube as shown.
18. Remove the O-ring from the air temp. sensor
as shown.
19. Install the sensor into the grommet installed in
step #17.
NOTE: Take care installing the air temperature
sensor, as it is very fragile.
20. Install the saddle clamp onto the tube mounting
bracket with provided hardware as shown.
21. Remove the rear lower A/C mounting bolt
shown.
NOTE: This bolt will be reused.
22. Using the bolt removed in step #21, install the
tube mounting bracket onto the A/C compressor as
shown.
23. Install the K&N
®
intake tube into the silicone
hose at the throttle body and onto the saddle
clamp, then secure with the provided hose clamps.
24. Reconnect the air temperature sensor electrical
connection as shown.
NOTE: It may be necessary to use the provided
temperature sensor wiring harness extension
on some models due to factory wiring harness
changes.
25. Install the provided crankcase vent hose onto
the factory “Tee” tting and then onto the K&N
®
intake tube as shown.
26. Install the lter adapter into the air lter as
shown and secure with the provided hose clamp.
27. Install the silicone hose (08630) onto the air
lter adapter and secure with the provided hose
clamps as shown.
10. Install the “L” bracket (010122) onto the heat
shield with the provided hardware as shown.