Owners manual

INSTALLATION INSTRUCTIONS
Continued
7. Pull the fresh air duct forward to disconnect
it from the airbox and then remove it from the
vehicle.
8. Remove the airbox mounting bolt shown.
9. Lift the lower airbox and remove it from the
vehicle as shown.
NOTE: K&N Engineering, Inc., recommends that
customers do not discard factory air intake.
10. Install the saddle clamp onto the “L” bracket
(07131) with provided hardware as shown.
11. Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim may be
necessary.
12. Install the saddle bracket assembly onto the
heat shield with the provided hardware as shown.
13. Install the “L” bracket (070952) onto the heat
shield with provided hardware as shown.
NOTE: Mount this bracket on the inside of the
heat shield with the “L” pointing to the outside.
14. Install the 1/4”-20 male/female rubber mounted
stud onto the “L” bracket (070952) with the
provided hardware as shown.
15. Install the bracket/rubber mounted stud
assembly onto the heat shield as shown using the
provided hardware.
16. Install the twist bracket onto the heat shield as
shown using the provided hardware.
17. Remove the bolt which secures the vacuum
reservoir to the airbox and then remove the reservoir
from the airbox.
18. Using the provided spacer, install the vacuum
reservoir onto the heat shield as shown.
NOTE: Due to vehicle manufacturing tolerances
2 spacers may be required.
19. Remove the coolant reservoir-retaining nut and
airbox mounting grommet shown.
20. Using the two fender washers and one rubber
washer, install the 6mm male/female rubber
mounted stud onto the lower airbox mount as
shown.
21. Install the 6mm male/male rubber mounted
stud onto the upper airbox mount as shown.
22. Install the heat shield assembly into the vehicle
and secure it to the mounting locations with the
provided hardware.
23. Reconnect the vacuum reservoir vacuum line.