Owners manual

INSTALLATION INSTRUCTIONS
Continued
9. Remove the 8 bolts that retain the inner fender
to the vehicle. To allow inner fender wall to drop for
access to the lower airbox mount bolts.
NOTE: Not necessary to remove tire to access
those bolts.
10. Use a 13mm wrench to remove the two bolts
that retain the lower airbox mount.
11. Use a 13mm wrench to remove the two bolts
that retain the upper airbox mount.
12. Remove the air box mount as shown.
13. Re-install the inner fender with the bolts that
was removed in step 7.
14. Unhook the A/C hose from the mounting clips
on the radiator fan shroud as shown.
15. Using the tie-wraps provided, strap the A/C
hose to the P/S hose as shown.
16. Assemble the saddle bracket assembly as
shown.
17. Remove the upper alternator mounting bolt as
shown.
18. Install the saddle bracket assembly onto the
alternator with bolt removed in step 17.
19. Install the heat shield side panel (074031) onto
the heat shield base (074030) with the “L” bracket
(07078) as shown with the provided hardware.
NOTE: The L bracket should be installed at the
center mounting location with the 16mm long
bolt. Do not completely tighten the bolts at this
time.
20. Install the heat shield side panel (074011) with
the provided hardware as shown.
21. Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim may be
necessary.
22. Install the provided edge trim into the hole in
the heat shield as shown.
NOTE: Some trimming of the edge trim may be
necessary.
23. Install the “L” bracket (070066) onto the
radiator core support with the provided hardware
as shown.
24. Install the “L” bracket (070712) onto the inner
fender with one of the bolts removed in step #11.
25. Install the heat shield assembly into the vehicle
and secure to the mounting brackets installed in
steps #23 and #24 with the provided hardware.
26. Install the heat shield mounting bolt through
the base of the heat shield and through the inner
fender well, secure with the provided nut.
NOTE: Be sure to use the two large fender
washers, one on the top and one on the
underside against the plastic inner fender.
27. Using the bolt removed in step #8, secure the
heater hose-mounting bracket to the “L” bracket
installed on the heat shield in step #19.