Owners manual

57-1541
NOTE: FAILURE TO FOLLOW INSTALLATION INSTRUCTIONS AND NOT USING THE PROVIDED HARDWARE
MAY DAMAGE THE INTAKE TUBE, THROTTLE BODY AND ENGINE.
1. Turn off the ignition and disconnect the negative
battery cable.
NOTE: Disconnecting the negative battery cable
erases pre-programmed electronic memories.
Write down all memory settings before
disconnecting the negative battery cable. Some
radios will require an anti-theft code to be
entered after the battery is reconnected. The
anti-theft code is typically supplied with your
owner’s manual. In the event your vehicles’
anti-theft code cannot be recovered, contact an
authorized dealership to obtain your vehicles
anti-theft code.
TO START:
TOOLS NEEDED:
NOTE: This kit was not designed
to t vehicles with a body lift.
DODGE
2004-06 RAM SRT-10
V10-8.3L
Description Qty. Part # Description Qty. Part # Description Qty. Part # Description Qty. Part #
A hose clamp #72 4 08671
B silicone hose 1 08623
C grommet; 1"od x 1/2"id 1 08064
D intake tube (ED) 1 087132
E tie wrap; 17" long black 2 21592
F silicone hose 1 084047
G saddle bracket 1 078855
H bolt; m6-1.00 x 20mm f/h/a 1 08376
I cup washer, black nylon 1 08180
J bracket; twisted "L" 1 010079
K washer; 1/4"id x 5/8"od, at 20 08275
L nut; 6mm nylock 11 07553
M edge trim 32" 1 102493
N edge trim 26" 1 102488
O bracket; medium "L" 1 070712
P bracket; large "L" 1 07078
Q bracket small "L" 1 070066
R bolt; m6-1.00 x 20mm, hex 1 07795
S washer; 1/4"id split lock 1 08198
T bolt; m6-1.00 x 16mm 4 07730
U bolt; m6-1.00 x 12mm 6 07794
V heat shield (A) 1 074030
W heat shield (B) 1 074031
X heat shield C 1 074011
Y washer; 1/4"id x 1"od 2 08160
Z silicone hose 7" 1 08159
AA hose mender; 1/2"od 1 08686
AB air lter 1 RF-1024
PARTS LIST:
Flat Blade Screwdriver
Ratchet
Extension
#27 torx socket
4mm Allen wrench
10mm Wrench
8mm Socket
10mm Socket
13mm Socket
9/16” Socket
2. Depress the locking tab and then disconnect air
temperature sensor electrical connection as shown.
3. Remove the idle air hose from the idle air
solenoid as shown.
4. Loosen the two hose clamps that secure the
intake tube to the throttle body and factory air box,
and then remove the intake tube from the vehicle.
5. Loosen the crankcase vent tube clamp, and then
disconnect the vent tube from the air box lid as
shown.
6. Remove the air box mounting nut shown.
7. Remove the air box assembly from the vehicle
as shown.
NOTE: K&N recommends that customers do
not discard factory air intake.
8. Remove the heater hose bracket mounting bolt
shown.