Owners manual

* FREE K&N
®
decal To register your warranty, please see us online at knlters.com/register. FREE K&N
®
decal *
INSTALLATION INSTRUCTIONS
Continued
1. Start the engine with the transmission in neutral
or park, and the parking brake engaged. Listen for
air leaks or odd noises. For air leaks secure hoses
and connections. For odd noises, find cause and
repair before proceeding. This kit will function
identically to the factory system except for being
louder and much more responsive.
2. Test drive the vehicle. Listen for odd noises or
rattles and x as necessary.
3. If road test is ne, you can now enjoy the added
power and performance from your kit.
4. K&N Engineering, Inc., requires cleaning the
intake system’s air lter element every 100,000
miles. When used in dusty or o-road
environments, our lters will require cleaning more
often. We recommend that you visually inspect
your lter once every 25,000 miles to determine
if the screen is still visible. When the screen is no
longer visible some place on the lter element, it is
time to clean it. To clean and re-oil, purchase our
lter Recharger
®
service kit, part number 99-5050
or 99-5000 and follow the easy instructions.
ROAD TESTING:
34. It will be necessary for all K&N
®
high ow
intake systems to be checked periodically
for realignment, clearance and tightening of
all connections. Failure to follow the above
instructions or proper maintenance may void
warranty.
• 1455 CITRUS ST., P.O. BOX 1329, RIVERSIDE, CA., U.S.A. 92502 • TECH SERVICE 800-858-3333 • FAX [phone]
• e-mail: tech@knlters.com
®
• WWW: http://www.knlters.com
®
33. The C.A.R.B. exemption sticker, (attached),
must be visible under the hood so that an
emissions inspector can see it when the vehicle
is required to be tested for emissions. California
requires testing every two years, other states may
vary.
32. Reconnect the vehicle’s negative battery cable.
Double check to make sure everything is tight and
properly positioned before starting the vehicle.
24. Reinstall the lower rubber air box locator
removed in step #11 and re-secure the heater
hose.
25. Secure the wiring harness clip removed in step
#21 to the heat shield as shown.
26. Install the provided bracket onto the heat
shield and inner fender with the provided hardware
as shown.
NOTE: The long portion of the bracket should
attach to the heat shield.
27. Install the factory fresh air tube into the heat
shield as shown.
28. Reinstall the fresh air duct removed in step #4
and secure with the four factory retaining pins.
29. Using the supplied silicone hose, attach the
factory vent hose to the npt tting on the intake
tube.
30. Reconnect the mass air sensor electrical
connection.
31. Install the air lter and secure with the hose
clamp provided.
NOTE: Drycharger
®
air lter wrap; part #
RU-4730DK is available to purchase separately.
To learn more about Drycharger
®
lter wraps
or look up color availability please visit http://
www.knlters.com
®
.
18478J
10/03/17