Owners manual

INSTALLATION INSTRUCTIONS
Continued
8. Lift up and remove the air box from the vehicle.
NOTE: K&N Engineering, Inc., recommends
that customers do not discard factory air
intake.
7. Unhook the wiring harness from the rear of the
factory air box.
9. Disconnect the vent tube from the factory intake
tube as shown.
10. Loosen the lower hose clamp and remove the
factory upper intake hose from the lower intake
hose.
11. Unstrap the heater hose from the lower air box
locator, and then pull up to remove the lower air
box locator from the vehicle.
12. Install the provided 1/4” npt tting into the
intake tube as shown.
NOTE: Plastic NPT ttings are easy to cross
thread. Install the vent tting “hand” tight, then
turn it two complete turns with a wrench.
13. Install the K&N
®
intake tube into the factory
lower intake hose and secure with the factory hose
clamp.
NOTE: Do not completely tighten the hose
clamp at this time.
14. Remove the factory fresh air hose from the air
box as shown.
15. Determine which style fresh air duct is used on
your vehicle and choose the corresponding heat
shield side panel that matches the assembly.
16. Assemble the heat shield using the side panel
selected from step #15 and the provided hardware.
17. Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim may be
necessary.
18. Trim the edge trim 1.5” as shown for clearance
at the radiator water neck.
NOTE: Trim just the bulb portion of the edge
trim leaving the pinched portion of the edge
trim on the heat shield.
19. Release the two clips that secure the mass air
sensor to the air box, then remove the mass air
sensor as shown.
20. Install the silicone hose (08690) onto the mass
air sensor and secure with the provided hose
clamp.
21. Using a pair of pliers, carefully remove the
wiring harness retaining clip from the inner fender
as shown.
22. Install the mass air sensor assembly onto the
K&N
®
intake tube and secure with the provided
hose clamp.
NOTE: Do not completely tighten at this time.
23. Install the heat shield assembly into the vehicle
and secure to the lower air box locating studs with
the provided hardware as shown. Pass the mass
air sensor through the hole in the heat shield.