Owners manual

INSTALLATION INSTRUCTIONS
Continued
23. Install the air lter onto the mass air sensor
and secure with the provided hose clamp.
NOTE: Drycharger
®
air lter wrap; part #
RC-4630DK is available to purchase separately.
To learn more about Drycharger
®
lter wraps or
look up color availability please visit
http://www.knlters.com
®
.
7. Pull up on the vent tube to dislodge it from the
intake tube as shown.
8. Loosen the lower hose clamp, which secures
the upper intake tube to the lower intake tube,
and then remove the upper intake tube from the
vehicle.
NOTE: K&N Engineering, Inc., recommends
that customers do not discard factory air
intake.
9. Unclip the rubber strap, which secures the
heater hose to the lower air box locator.
10. Pull up the lower air box locator to remove it
from the mounting studs and then from the vehicle.
11. Install the provided grommet into the intake
tube as shown.
12. Install the intake tube into the factory lower
intake tube and secure with the factory hose
clamp.
NOTE: Do not completely tighten the hose
clamp at this time.
13. Insert the factory vent tube into the grommet in
the intake tube as shown.
14. Install the provided edge trim onto the heat
shield as shown.
NOTE: Some trimming of the edge trim may be
necessary.
15. Remove the fresh air duct from the air box as
shown.
16. Install the fresh air duct into the heat shield as
shown.
17. Install the heat shield assembly into the vehicle
and secure with the provided fender washers and
6mm nuts onto the lower air box mount studs. Re-
install the fresh air hose into the fresh air duct.
18. Reinstall the lower air box locator removed in
step #10 and resecure the heater hose.
19. Unhook the two mass air sensor retaining clips
and remove the mass air sensor from the air box.
20. Install the silicone hose (08630) onto the mass
air sensor and secure with the provided hose
clamp.
21. Install the mass air sensor assembly into the
heat shield and onto the K&N
®
intake tube, secure
with the provided hose clamp.
22. Secure the provided bracket (010087) onto
the heat shield and inner fender with the provided
hardware as shown.
NOTE: The long side of the bracket attaches to
the heat shield.