Owners manual

Installation Instructions

Part Number 33-2398

This ﬁ lter ﬁ ts: See catalog for current applications

Congratulations, you have purchased the ﬁ nest air ﬁ lter that money can buy. With proper care, this

ﬁ lter will last 1 million miles or more. This ﬁ lter is a direct replacement for the stock air ﬁ lter, and no

modiﬁ cations will be required. However, the following procedures MUST be followed to ensure the

proper ﬁ t and seal of the K&N Air Filter.

Installation

THESE INSTRUCTIONS MUST BE FOLLOWED EVERY TIME THE FILTER IS

SERVICED, OTHERWISE THE FILTER MAY NOT SEAL, AND DAMAGE TO THE

ENGINE COULD RESULT.

•1455 Citrus St. P.O. Box 1329, Riverside, C.A. USA 92502 • Tech Service 800-858-3333 • Fax 951-826-4001•

•Email: tech@knﬁ lters.com • WWW: http://www.knﬁ lters.com•

1. Locate the plastic cover on the driver’s side of the engine. (Fig 1)

2. Locate the words “Clip Behind” on the plastic cover, pull the cover up from this location. (Fig 2)

3. Remove the plastic cover, set it aside, then locate the air box.

4. Un-clip the two metal clips on the top of the air box, (Fig 3) pull up, the lid will slide out.

Remove the lid and set it aside.

5. Remove the OE ﬁ lter by using the tab and sliding the ﬁ lter out. Dispose of the OE ﬁ lter. (Fig 4)

6. Remove the K&N ﬁ lter from the package. Check to ensure that the K&N ﬁ lter and plastic cage

are seated together.

7. Using the tab on the plastic cage, (Fig 5) slide the K&N ﬁ lter into the air box (Fig 6).

8. Slide the lid back into the air box. Ensure the lid is seated all the way down and re-clip the

metal clips. (Fig 7)

9. Re-install the plastic cover.

Note: When cleaning, the K&N ﬁ lter must be removed from the plastic cage.

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5

Fig. 6

Fig. 7

18756

01/15/08