Product Manual

1. From the right side of
the tractor, remove
the pan head screw in
the upper right corner,
located above the
existing mirror bracket.
2. Place the new
mounting bracket in
the upper right corner
and temporarily secure it
with a #10 x 3/4” screw
using the hole from the
screw removed in step 1.
3. Mark the location of the
other three holes, then
remove the mounting
bracket.
4. Using the included #1
drill bit with the stop
collar set at 5/16” from
the tip of the bit, drill the
two holes for the 1/4” x
1/2” thread cutting
screws.
USE CAUTION! There
are air conditioning
lines and electircal wires in the posts.
5. Use a 1/8” drill bit to drill the hole for the #10 x 3/4” screw.
6. Secure the mounting bracket, being sure to use the 1/4” flat washer behind the bottom hole of the mounting
bracket.
7. Fasten the mirror arm assembly to the mounting bracket with two 5/16” x 1” full thread bolts, flat washers,
lock washers and nuts.
8. Insert the small tube into the mirror arm assembly and secure with the plastic mirror knob.
9. Fasten the mirror head to the small pipe with the 2” clamp and included hardware.
Small Tube
PN: 10622
2” Clamp
PN: 10613
Mirror Head
PN: 3110
Plastic
Mirror Knob
PN: 85108
Mounting
Bracket
PN: 10618
Installation Guide
Mirror Arm
Assembly
PN: 12171
CIH Magnum Mirror - Right (PN: 3128)
Note!
Do not overtighten the plastic mirror knob.
Fits:
CIH Magnum 7100-7200 Series
004-CIH-3128-000
1.800.328.1752 / www.tractorseats.comCustomer Support
1/4” X 1/2” Thread
Cutting Screw
#10 x 3/4”
Screw
#10 x 3/4”
Screw
1/4”
Washer