Product Manual

JD 7000 Series Cab Foam Kit - PN: 4212
Fits Models: 7000, 7200, 7210, 7400, 7410, 7510, 7600, 7610, 7700, 7710, 7800 and 7810 (Corner Post Complete Kit - PN: 4213)
Phone - 800.328.1752
Fax - 320.329.3709
Email - [e-mail]
Web Site - www.tractorseats.com
P.O. Box 409 - 308 NW 2nd Street
Renville, MN 56284
1. To make installation of your new cab foam kit easier, remove seat to allow more room to work. Also
remove floor mat, ashtray, radio, AC and heater controls and vents in models where necessary.
2. When removing the old foam, take note which pieces overlap each other as this will be
important when installing your new cab foam kit.
3. Remove existing foam and old glue residue as much as possible using a putty knife, wire brush, etc.
If there is oil present on the walls of the cab, this must also be removed with a solvent. (Make sure
this is done in a well ventilated area.)
4. Before gluing in the new pieces, dry fit them into their position first to see if any trimming is
necessary. (Use a sharp utility knife to do any trimming.) When ready to install permanently, spray
both the foam and the cab wall with adhesive. To prevent wrinkling, start gluing down one edge of
the piece of foam and work your way to the opposite edge.
6 Pcs. - Brown [Multi] Material PN: 4083
Left Fender
Top Panel
PN: 42714
Rear Center
Panel
PN: 42715
Left Rear Post
PN: 42716
Not Included
Right Rear Post
PN: 42717
Not Included
Right Front Post
PN: 42719
Not Included
Headliner
PN: 4535 (Vinyl)
PN: 4549 (Cloth)
Not Included
Right Rear
Panel
PN: 42721
Left Rear
Panel
PN: 42722
Right Fender
Panel
PN: 42723
003-JD-4212-004
Note!
Left Fender Top Panel and
Left Fender Side Panel
replace the original single
panel in the cab.
Front of
Tractor
Left Fender
Side Panel
PN: 42718
Left Front Post
PN: 42720
Not Included