Product Manual

JD 50 Series Cab Foam Kit - 2WD - PN: 4062
(Corner Post Complete Kit - Part No. 4065)
Phone - 800.328.1752
Fax - 320.329.3709
Email - [e-mail]
Web Site - www.tractorseats.com
P.O. Box 409 - 308 NW 2nd Street
Renville, MN 56284
1. To make installation of your new cab foam kit easier, remove seat to allow more room to work. Also
remove floor mat, ashtray, radio, AC and heater controls and vents in models where necessary.
2. When removing the old foam, take note which pieces overlap each other as this will be
important when installing your new cab foam kit.
3. Remove existing foam and old glue residue as much as possible using a putty knife, wire brush, etc.
If there is oil present on the walls of the cab, this must also be removed with a solvent. (Make sure
this is done in a well ventilated area.)
4. Before gluing in the new pieces, dry fit them into their position first to see if any trimming is
necessary. (Use a sharp utility knife to do any trimming.) When ready to install permanently, spray
both the foam and the cab wall with adhesive. To prevent wrinkling, start gluing down one edge of
the piece of foam and work your way to the opposite edge.
9 Pcs. - Brown [Brindle] Material PN: 4012, 4014, 4103
Right Fender
Panel
PN: 42467
Left Fender
Panel
PN: 42468
Front Right
Panel
PN: 42466
Front Left
Panel
PN: 42465
Right Rear
Panel
PN: 42457
Left Rear
Panel
PN: 42458
Lower Right
Rear Panel
PN: 42460
Lower Left
Rear Panel
PN: 42459
Lower Rear
Panel
PN: 42456
Right Front
Post Cover
PN: 42461
Not Included
Left Front
Post Cover
PN: 42462
Not Included
Right Rear
Post Cover
PN: 42463
Not Included
Left Rear
Post Cover
PN: 42464
Not Included
003-JD-4062-005
Front of
Tractor