User manual

92798 Cape Arago Hwy, Coos Bay, OR 97420 | 541-888-3517 | Toll Free 800-867-6863 | kksound.com
5
12. Remove the brown protective paper from the double stick tape on the pickup and bring the pickup into
position. Use upward pressure on the installation tool to firmly press the pickup to the soundboard.
13. Carefully remove the installation tool. Again, it should come off with
the putty on it.
Once you removed the tool, remove the putty from it and use the
installation tool (without putty) to apply more upward pressure to
different areas of the pickup to ensure secure adhesion.
Now both transducers are successfully installed. All that is left is
fastening the carpenter jack clamp.
14. Bring the carpenter jack in position and use use a fitting tool (like a
small Allen wrench that fits the holes in the barrel screws) to tighten
the clamp as shown.
Once it is secure, make sure the cable is aligned properly over the
edge of the F hole (see picture) and the cables inside the instrument
are free and not touching the mandolin.
We recommend a K&K Pure Preamp or a K&K Pure XLR Preamp with this setup in order to have great sound
with any amp/PA and in any situation.