User manual

92798 Cape Arago Hwy, Coos Bay, OR 97420 | 541-888-3517 | Toll Free 800-867-6863 | kksound.com

6. Stick the putty over the bent nail (your installation tool) onto the

labeled-black side of the pickup. Make sure to hold the pickup so the

cable leads towards the bottom of the mandolin once the pickup is

attached to the soundboard. The putty will temporarily hold the pickup

to the bent nail.

Test if the brace inside the mandolin allows free access to the pickup’s

desired location. By holding on to the nail you can carefully move the

pickup around inside the mandolin and test the fit. Aim for a spot next

to the widest part of the F hole, closest to the bridge.

Once you’ve established the desired spot make sure the putty still

securely adheres to the pickup. It can be re-shaped and re-positioned if

needed.

7. Remove the brown protective paper from the double stick tape on the

pickup and bring the pickup into position.

8. Use upward pressure on the installation tool to firmly press the pickup

to the soundboard.