Installation Instructions

K&H Manufacturing, Inc.

LECTRO TEMP CONTROL

Thank you for purchasing K&H Manufacturing’s LECTRO TEMP CONTROL. When

used properly, this unit should provide years of hassle free service.

INSTRUCTIONS

1. Plug your LECTRO TEMP CONTROL into a 110-120 volt electrical outlet protected

from weather, water or possible animal damages.

2. Plug your LECTRO-KENNEL heated pet pad into the LECTRO TEMP CONTROL

unit.

3. Turn knob counterclockwise to high position. This allows full current to reach the

heating element. Wait 1-2 hours.

4. Test pad warmth by placing hands on the LECTRO-KENNEL for 10-15 seconds to

feel the radiant heat.

5. Turn adjustment knob clockwise slightly. Wait 30 minutes or more and test pad heat

by using above procedure.

6. Continue above step until desired temperature is achieved.

7. You can decide on different day and night settings as long as outside conditions don’t

change radically.

8. NEVER plug more than one LECTRO-KENNEL into the LECTRO TEMP

CONTROL.

PAGE 1
K&H Manufacturing, Inc. LECTRO TEMP CONTROL Thank you for purchasing K&H Manufacturing’s LECTRO TEMP CONTROL. When used properly, this unit should provide years of hassle free service. INSTRUCTIONS 1. Plug your LECTRO TEMP CONTROL into a 110-120 volt electrical outlet protected from weather, water or possible animal damages. 2. Plug your LECTRO-KENNEL heated pet pad into the LECTRO TEMP CONTROL unit. 3. Turn knob counterclockwise to high position. This allows full current to reach the heating element.