User guide

Mount Installation:

1. Ensure the stem and handlebars are installed, aligned, and torqued according to manufacturer’s recommendations.

2. Remove the original top cap and mounting bolt.

3. Install K13-551 on top of the stem.

4. Install, but do not fully tighten, M6 x 35mm FHCS.

5. Set the mount to your desired position (see above).

6. Carefully tighten the top cap bolt (M6 x 35mm FHCS) according to the manufacturer’s recommendations for the

headset.

7. Install K13-503 Garmin Insert.

8. Install the 2x M3 x 6mm FHCS and torque to 1 N-m MAX.

Caution: Do not over-torque the M3 x 6mm Flat Head screws.

Notes:

• A small amount of thread lock has been pre-applied to the M3 x 6mm bolt at the factory, it is

recommended that an additional amount be added if this bolt were to be adjusted multiple times.

• Subsequent adjustment or tightening of the M6 x 35mm headset bolt will require removal of the two M3

x 6mm FHCS bolts.

WARNING: IT IS STRONGLY RECOMMENDED THAT YOU PERIODICALLY CHECK ALL BOLTS FOR PROPER TORQUE!!!