User Manual

K13-450 (Pictured Below):
NOTE REGARDING ALIGNMENT BOLT:
Some cameras have alignment hole(s) to prevent rotation and maintain alignment. This ‘alignment hole’ can be seen
next to the ¼”-20 tapped hole on your camera. If you have this hole (located directly behind the ¼”-20 tapped hole - you
can use the supplied alignment bolt with your mount. If you do not have this ‘alignment hole’, or is not in the desired
position, remove the alignment bolt and install it on the opposite side of the mounting arm (same side as the head of the
thumbscrew)
1. Attach a compatible camera with a ¼”-20 universal mount to the mount with the ¼”-20 Thumbscrew.
2. Tighten by hand.
3. Adjust to desired position
4. Torque the ¼”-20 Thumbscrew according to the manufacturer’s recommendation for the given camera.
5. Attach the K13-450 adapter to a compatible Go Big Mount.