User's Manual
Table Of Contents
- 1. Introduction
- System Basic Features
- Technological Characteristics
- 4. Product Overview
- 5. Interface
- 6. Environmental Condition
- 7. Software Installation
- 8. Arbeit NMS software
- _
- 8.3.1 IDU Setting
- 8.3.2 ODU Setting
- 8.3.3 Alarm Setting
- 8.3.4 Cross Connecting
- 8.3.5 User I/O Setting
- 8.5.1 Background Setting
- 8.5.2 COM port Setting
- 8.5.3 Record Saving Time
- Local Loopback
- IF Loopback
- RF Loopback
- Remote Loopback
- PRBS Test
- 8.8.1 Alarm Record
- 8.8.2 Login Record
- 8.9.1 Help Window
- 8.9.2 About Arbeit
- 8.10.1 Network Monitor
- 8.10.2 Real-time Alarm
- _
- Appendix A: Technical Specifications
- Appendix B: LCD Alarm Description
- Appendix C: LCD Display＆Function Table
- Appendix D: Frequency Spread Spectrum
- Appendix E: 5.8GHz ODU Block Diagram
- Appendix F: ODU Installation Guide
- Appendix G: RSL Calculation and Link Budget
- Appendix H: Arbeit Network Management System Tree
- Appendix I: Arbeit NMS Alarm
- Appendix J: ODU Troubleshooting Guide
- Appendix K: Antenna
5.8GHz PDH User’s Manual
37
DSC No：Enter any number between 0~255 for digital service telephone number setting.
Note that the DSC number should be different from the Link ID. On the right side of the IDU
panel, there is a RJ-11 connector meant for analog telephone, which is used for all phone
connection in the route with the base station.
Panel PWD：This function is not open to all users owing to the fact that while setting the
IDU in the local end, some of the functions are still in process which will cause the full
breakdown of the machine. If necessary, enter the IDU password, which must only be 0~9
digits, ranging from 0~999999.
A.T.P.C：Automatic transmitting power control
Expected RSL：Automatic transmitting power control parameters
Code Format：IDU transmission encoding format AMI or HDB3
BER Alarm Threshold：BER alarm setting: E-5、E-4、E-3 etc.
Check：Check all the IDU setting data
Exit：Exit the initialization mode after all IDU setting.