User's Manual
Table Of Contents
- 1. Introduction
- System Basic Features
- Technological Characteristics
- 4. Product Overview
- 5. Interface
- 6. Environmental Condition
- 7. Software Installation
- 8. Arbeit NMS software
- _
- 8.3.1 IDU Setting
- 8.3.2 ODU Setting
- 8.3.3 Alarm Setting
- 8.3.4 Cross Connecting
- 8.3.5 User I/O Setting
- 8.5.1 Background Setting
- 8.5.2 COM port Setting
- 8.5.3 Record Saving Time
- Local Loopback
- IF Loopback
- RF Loopback
- Remote Loopback
- PRBS Test
- 8.8.1 Alarm Record
- 8.8.2 Login Record
- 8.9.1 Help Window
- 8.9.2 About Arbeit
- 8.10.1 Network Monitor
- 8.10.2 Real-time Alarm
- _
- Appendix A: Technical Specifications
- Appendix B: LCD Alarm Description
- Appendix C: LCD Display&Function Table
- Appendix D: Frequency Spread Spectrum
- Appendix E: 5.8GHz ODU Block Diagram
- Appendix F: ODU Installation Guide
- Appendix G: RSL Calculation and Link Budget
- Appendix H: Arbeit Network Management System Tree
- Appendix I: Arbeit NMS Alarm
- Appendix J: ODU Troubleshooting Guide
- Appendix K: Antenna
5.8GHz PDH User’s Manual
11
Out-of-order tone: When there is an out-of-order service or lost of signal service, it will ring
the out-of-order tone at 500±50ms, 230ms±70ms and then break
connection
Busy tone: Continue to redial at an exchange of 500ms±50ms
5.2.2 Definition of the IDU LCD Panel keys
ESC ALT
Left Right OK
For the LCD to fully display the system’s status and perform those simple set up operations,
try to make use of the above-mentioned five
function keys to carry out the operations.
LCD displays the contents and different set-up entries. As described below, please apply
as mentioned.
IDU LCD Display
ESC = exit
ALT =
switch
functions
Left = left arrow
Right = right arrow
OK = confirm