User's Manual

list [start/end]: display the content of the access control mode and the address list. The
optional arguments, start and end, can be affixed to select the range of items
to be listed.
clear: clear all the addresses in the access control table.
WEP Keys
wep mode | set | list
The 'wep' command contains sub-commands that allow you to manage the data encryption
(WEP, wired equivalent privacy) function provided with the ODU. The sub-commands are
listed as follows:
mode disable | wep64: set the access control mode. The following are the definition of
each data encryption mode.
• none: no encryption (default)
• wep64: use 64-bit WEP data encryption
• wep128: use 128-bit WEP data encryption
set key1 key_text: set WEP Key#1 as key_text. 10 hexadecimal digits (0-9 or A-F)
heading by “0x” or five alphanumeric values (ASCII characters,
case-sensitive) are required if 64-bit WEP is used.
Example: 0x1122334455, 0x0055AA55AA, abcde, or MyKey.
set key2 key_text: set WEP Key#2 as key_text with a same format as WEP Key#1.
set key3 key_text: set WEP Key#3 as key_text with a same format as WEP Key#1.
set key4 key_text: set WEP Key#2 as key_text with a same format as WEP Key#1.
set usekey 1|2|3|4: Select the WEP key to be used for encrypting data transmission. Only
one key can be selected at a time.
list: Display current WEP settings.