User's Manual

Textmenu Details
E1 Spread Spectrum Radios
8-9
Trap: This item allow you to set the Trap function of SNMP.
Figure 8-13 Trap
Trap/Generate authentication-failure traps: This item can be set as “YES” or “NO”. When set as “YES”, if
there’s an intrusion by unauthorized user, an illegal “Trap” will occur. The default setting is “YES”.
Trap/Trap Alarm Setting: This item can select “Critical”, “All”, or “None”. After selection, when an alarm is
issued under the denoted setting, a trap will be cast upon the destination address. The default setting is “All”.
Trap/Destination: As the Trap destination address. The system could support up to 10 trap destinations.
Trap/Community: As the Trap community string setting.
SNMP ReadOnly Community: This item allows you to change community of “GET” command.
9 The default value is “Public”.
SNMP ReadWrite Community: This item allows you to change community of “SET” command.
9 The default value is “Private”.