User's Manual

E1 Spread Spectrum Radios
9-7
6 IF-Loop: En/Dis Set IF Loopback
Perform loopback test from IF interface for
the convenience of testing the IDU’s
stability
7 RF-Loop: En/Dis Set RF Loopback
Perform loopback test from RF interface for
the convenience of testing the IDU’s
stability
8 Close-Test: Y/N Close all test Y: close N: cancel
1 Remote ID: n Display the remote address
Display the address of the remote
equipment; n=1~255
2 R-Status: OK/Loss
Display the system current
working status
Test: remote end in test mode Normal:
normal working condition
3 Far-end OK/Loss
Display the connection status
of remote end
OK: in connection
Loss: remote monitor function lost
Remote
Info
(D)
4
R-AUX2:
ASY-CH/SYN-CH
Display remote AUX2 status Display remote AUX2 status
1
MODEM: On/Off
Display remote dialup modem
status
Display if any remote dialup modem is
connected or not
2
SYS-Conf: 1+ 0
Display system configuration
standby mode
Display if there is any standby support
3
TX: Active Display transmitting status Display in Active or Standby mode
4
RX: Active Display receiving status Display in Active or Standby mode
5
Power: -36 ~ -72V Display input power Display input power
6
Date: Year/Month/Day Display current date Display current date
Config
Info(E)
7
Time: Hour/Min/Sec Display current time Display current time