Owner's manual
21
rev.A
KN6 - KN10S
12. KN10 TECHNICAL DETAILS
KN10S
Acoustics
Power handling 2 x 250 w
(AES)
Maximum amplier power 2 x 500 w
(EIAJ)
Impedance 2 x 4 Ω
Operating frequency range 30Hz - 150 Hz +/- 3dB (preset dependent)
Frequency range 40Hz - 150 Hz +/- 3dB (preset dependent)
SPL 1W/1mt 95 dB
Maximum SPL 124dB continuous - 130 dB peak
Coverage
Horizontal Omni
Vertical Omni
Crossover
Type DSP controlled
Frequency 150 Hz minimum (preset dependent)
Transducers
Low - Mid frequency 2 x 10” Neodymium speakers with 2” voice coil
Audio Input
Connectors male + female parallel 3-pin balanced XLR
Wiring PIN1= ground PIN2 = hot PIN3 = cold
Power Input
Connector 1 x PowerCon
Ampliers
Type
1 module class D - DSP controlled
Power (woofer)
350 + 350 Watt
1
Protection Dynamic limiter, over current, over temp, short circuits
AC power
Operating range 85 - 270 Vac 50/60Hz autorange
Max continuous
and burst current
140VA(>10 sec) - 700VA (<1 sec) autorange
Physical
Dimensions 50.5 x 33.5 x 28 cm (19.88”x 13.19”x 11.02”)
Weight 17 Kg (37.48 lbs)
Notes for data
1. Amplier wattage rating is based on the maximum unclipped burst sine wave RMS voltage that the
amplier will produce into the nominal load impedance .
New materials and design are introduced into existing products without previous notice. Present
systems may differ in some respects from those presented in this brochure.