User's Manual

3
4. DURING INSTALLATION, DO NOT OPERATE
TRANSMITTER WITHOUT ANTENNA
CONNECTED TO ANTENNA PORT. Failure to
do so will result in damage to the unit and void the
warranty.
5. The transmitter is FCC approved under FCC ID:
OPH-MINITX4000. Changes or modifications
not expressly approved by K&A Wireless, LLC
will void the user’s authority to operate the
equipment.
6. This product must be professionally installed.
Additional installation instructions will be
provided to professional installers to insure
compliance with RF exposure requirements and
must be for occupational use only and cannot be
used in public applications.
7. The radio and its antenna is required to be
mounted and kept at least 20 cm away from any
part of the user’s torso or head and must not be
co-located or operating in conjunction with any
other antenna or transmitter.
8. In host devices where the distance between the
antenna and the body of the user is equal to or less
than 20 cm, the device must be evaluated using
specific FCC and Industry Canada test
procedures for SAR and requires separate
approval. Users are required to consult with
K&A Wireless LLC for all portable installations.
The modular transmitter must have buffered
modulation/data inputs (if such inputs are provided) to
ensure that the module will comply with part 15
requirements under conditions of excessive data rates or
over-modulation. Modular TX uses Analog Frequency
Modulation. It requires the modulation video signal to be
limited to 1Vpp. This is clearly noted in the Users Manual.