User's Manual
10
Transmitter Installation
The transmitter is designed to be integrated into your camera
system. To install the transmitter, connect the red wire to the
battery (or regulator output), connect the black wire to ground
or the negative terminal of your battery (or regulator output).
For the video connection, you should have requested either a
high-Z or low-Z video input. This is the termination setting. If
a low-Z input is required (this is in cases where the camera is
directly tied to the transmitter with no other connections), the
transmitter will measure approximately 75ohms at the video
leads. In this case, confirm that the voltage coming from the
camera does not exceed 1Vp-p. FAILURE TO DO SO
WILL VIOLATE FCC LICENSE APPROVAL.
In cases where a high-Z setting is requested, (when the camera
is required to drive a monitor and a transmitter without any
video buffer amplifiers in the camera), the video input on the
transmitter will measure approximately 1kOhm. In this case,
confirm that both the monitor (or load) is connected and the
transmitter is also connected. Measure the impedance of the
parallel combination and confirm that is measures
approximately 75ohm. Connect the video to the camera
(confirm that the yellow transmitter video wire is connected to
the positive video connection on the camera). In this case,
confirm that the video level at the transmitter does not exceed
1Vp-p. FAILURE TO DO SO WILL VIOLATE FCC
LICENSE APPROVAL.
Apply power to the camera and confirm that the camera is
functional.
Additional documentation may be provided for specific
installations.