User's Manual
Table Of Contents
- K&A Wireless, LLC
- TABLE OF CONTENTS
- SAFETY NOTICES
- THIS DEVICE IS FOR PART 90 LICENSED OR EXPORT USE ONLY. Equi
- This product is intended for use in occupational/controlled
- This is NOT an intrinsically safe device. Do not take into
- DURING INSTALLATION, DO NOT OPERATE TRANSMITTER WITHOUT ANTE
- The transmitter is FCC approved under FCC ID: OPH-EV4600. C
- This product must be professionally installed. Additional i
- The radio and its antenna is required to be mounted and kept
- THIS DEVICE IS FOR PART 90 LICENSED OR EXPORT USE ONLY. Equi
- PARTS LIST
- PRODUCT DESCRIPTION
EV-TX-4500 Installation Manual… 5
PARTS LIST
The EV-4000 series Analog Video Transmission system
comes complete with the following items:
1. EV-TX-4600 transmitter
2. TX-S-2018-MMCX-RTA antenna
The transmitter operation can be confirmed by using a EV-
RX-4600 series receiver unit from K&A. This receiver series
displays the video images on an NTSC compatible (PAL
compatible, if your camera source is PAL) monitor.
Additional accessories available through K&A Wireless:
1. Dipole antenna for receiver
2. 12-dB panel antenna for receiver
3. 5-dB vehicle-mounted antenna with magnetic
base for receiver
4. 7-dB vehicle mounted antenna for receiver
5. 9-dB vehicle-mounted antenna for receiver
6. 11-dB vehicle mounted antenna for receiver
PRODUCT DESCRIPTION
The EV-TX-4600 series transmitter is a two-channel analog
FM, video transmitter operating in the 2.4 GHz ISM band.
The EV-TX-4600 series provides a cost effective solution to
long-range transmission available for industrial,
government/municipality or for export applications.
The ISM band is a harmonized band and is available
worldwide. In the US, however, the EV-TX-4600 series
transmitter is designated for PART 90 use and requires a
license to be obtained by the end user.
EV-TX-4500 Installation Manual… 6
_______________________________________________________________
2617 JUAN TABO NE SUITE A, ALBUQUERQUE, NM 87112 PHONE
888.536.5207 FAX 505.338.2382 sales@ka-wireless.com
In addition to the enhanced performance, the EV-TX-4600
series provides a rudimentary security feature, which
decreases the ability of unwanted parties from receiving and
re-broadcasting the transmitted signal. Keep in mind that with
the addition of the security feature, the receiver and
transmitter will not work with off-the-shelf transmission
systems.
Transmitter
The EV-TX-4600 series transmitter is shown in Figure 1. The
transmitter is packaged for integration inside a camera only. It
has four (4) wires available - two wires (black - and red +) for
power, two (2) wires for video (yellow + and purple -) and a
channel change wire (ground for channel 2, open for channel
1). The system must be installed to operate at a minimum of
20 cm away from all persons.
_______________________________________________________________
2617 JUAN TABO NE SUITE A, ALBUQUERQUE, NM 87112 PHONE
888.536.5207 FAX 505.338.2382 sales@ka-wireless.com