User's Manual

EV-TX-4500 Installation Manual… 4
.
2617 JUAN TABO BLVD. NE, SUITE A, ALBUQUERQUE, NM 87112
PHONE [phone] FAX [phone] [e-mail]
EV-TX-4500 Installation Manual… 3
SAFETY NOTICES
VI. This product must be professionally installed.
Additional installation instructions will be provided to professional installers to insure compliance with RF exposure requirements and must be for occupational use only and cannot be used in public applications.
I. THIS DEVICE IS FOR PART 90 LICENSED OR
EXPORT USE ONLY. Equipment may be operated only with a Part 90 license issued by the FCC. The user is responsible for operating the equipment in compliance with FCC rules. Operation of this equipment without a valid FCC license could result in the issuance of fines to the user, or the seizure of the equipment.
VII. The radio and its antenna is required to be
mounted and kept at least 20 cm away from any part of the user’s torso or head and must not be co-located or operating in conjunction with any other antenna or transmitter.
II. This product is intended for use in
occupational/controlled conditions, where users have full knowledge of their exposure and can exercise control over their exposure to meet FCC limits. This device is not authorized for general population, consumer or any other use.
FCC NOTICE
The equipment has been tested and found to comply with the limits of a CLASS B device pursuant to PART 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference.
III. This is NOT an intrinsically safe device. Do not
take into area where intrinsic safety is required. Bodily harm may result if warning is ignored.
Emission designator for the EV-TX-4600 series transmitter unit is: 16M5F3F.
IV. DURING INSTALLATION, DO NOT OPERATE
TRANSMITTER WITHOUT ANTENNA CONNECTED TO ANTENNA PORT. Failure to do so will result in damage to the unit and void the warranty.
The transmitter label is shown below. Please confirm that the label on the transmitter is conforms to the label shown. Any transmitters having a non-conforming label will be in violation of the license.
EYE-View™Transmitter
Model No: EV-TX-4600
FCC ID: OPH-EV4600
S/N: EV-TX-XXXXXX
Made in USA
V. The transmitter is FCC approved under FCC ID:
OPH-EV4600. Changes or modifications not expressly approved by K&A Wireless, LLC will void the user’s authority to operate the equipment.
Figure 1. FCC label on every EV-TX-4600 series unit.
.
2617 JUAN TABO BLVD. NE, SUITE A, ALBUQUERQUE, NM 87112
PHONE [phone] FAX [phone] [e-mail]