User Guide

1. Loosen the Phillips head screws in the fasteners that secure
the top of the grill. NOTE: Some model years have fasteners
that have a center post to pry out instead of screws.
2. Carefully remove the 6 fasteners by prying them up at the
base using a flat blade screw driver. Save the 6 fasteners.
5. Use a T15 Torx driver to remove the 4 screws holding the
headlight retaining ring. Save the 4 screws.
6. Remove the retaining ring and headlight from the
mounting ring.
3. Carefully remove the front grill by pulling the TOP portion
forward until it unsnaps. Start near one headlight and work
across to the other light.
4. Carefully unsnap the clips at the bottom of the grill and
let it rest across the bumper. NOTE: These clips may break if
not treated with care.
Page 2
Installation Instructions
J.W. Speaker Corporation • Germantown, WI U.S.A. • www.jwspeaker.com • [e-mail] • 262.251.6660
Rev: 11/15/2017