User Manual
Installation Instructions
1. Detach your existing tail light by unscrewing the two inside
screws. Keep these screws.
2. Unplug the connector from the back of the existing tail light.
5. Secure the nut on the back of the resistor mounting
bracket with a pair of pliers OR adjustable wrench, then
tighten both screws with a Phillips screwdriver.
6. Align and attach the provided Tinnerman S-clips on resistor
mounting bracket. The rounded edge should be on the same
side as the resistor. Leave about 1 inch of space between clips.
3. From the bag of parts provided, line up the holes on the
resistor with the holes on the resistor mounting bracket.
4. Feed the provided screws through the top of the resistor
and attached the provided nuts by hand.
Page 2
J.W. Speaker Corporation • Germantown, WI U.S.A. • www.jwspeaker.com • speaker@jwspeaker.com • 262.251.6660
6544230bRev: 05/19/2016