Manual

Getting started
You can enhance the sound quality by connecting the unit's DIGITAL OUT to the digital input of an amplifier, DAT or
MD by using an optional digital cable. The digital audio signal from a disc is directly transferred. If you connect the
unit to a Dolby Digital, DTS or MPEG Multichannel decoder or an amplifier with a builtqn decoder by using an
optional digital cable, you can enjoy high-quality surround sound.
When you make the digital connection, also make the analog connection, because, depending on the disc type, no
audio may be reproduced from the DIGITAL OUT.
The unit
When using the DIGITAL OUT
(OPTICAL) jack, remove the protection
cap. Do not lose the removed cap.
When the jack is not used, fix the
protection cap into the jack.
Optical digital cable
(not supplied)
!! . ig_a)l ca ble
, iilolcable (not in°ilsll Pl _ : DigitalleqL_PAint ___ TI_GITAL
• When you connect the unit's DIGITAL OUT to digital audio equipment, before using, make the "DIGITAL AUDIO OUTPUT"
setting in the "AUDIO" page of the preference display correctly according to the connected audio equipment. If the "DIGITAL
AUDIO OUTPUT" is not set correctly, loud noise may be generated from speakers, causing damage to your speakers. See
"DIGITAL AUDIO OUTPUT" on page 44.
• w_ththedigita_c_nnecti_n_theunit_ssettingsf_r__MPREss__NandD_wNM_X_ntheAUD__page_fthepreferencedisp_ay
are invalid. Settings for these items must be made from the decoder.
When all the audio/video connections have been made, insert the smaller plug of the supplied AC power cord to the
unit's ,x, AC IN connector, then insert the other end to the wall outlet. Make sure that plugs are inserted firmly. The
STANDBY indicator lights and setup is completed.
matieally accommodates AC power between 110 V and 240 V. You do not need any setting to match the unit with
er voltage.
/_ Warning
• Disconnect the power cord if you are not going to use the unit for a long time.
• Disconnect the power cord before cleaning the unit.
• Disconnect the power cord before moving the unit.
• Do not connect or disconnect the power cord with wet hands.
• Do not pull the power cord when disconnecting it, as this may damage the cord and cause fire, electric shock, or
other accidents.
/_ Caution
• Do not damage, alter, twist, or pull the power cord, as this may cause fire, electric shock, or other accidents.
• To prevent any accidents or damages caused by an unsuitable AC power cord, only use the supplied power cord. If
the cord is damaged, contact a dealer and get the new power cord.
• Do not put anything heavy, or the unit, on the power cord, as this may cause fire, electric shock, or other accidents.
]
14