Computer Monitor User Manual

14
How to Use the MAIN MENU
The MAIN MENU contains the functions for daily use.
Operation guide
Shows the buttons for
each operation.
7 MAIN MENU items
BACK LIGHT
Adjusts the brightness of the display.
Setting value: 00 - 25
APERTURE
Adjusts the clearness of the picture.
Setting value: 00 - 10
CTI.
Adjusts the clearness of the outlines of the color signals
(R/G/B).
Setting value: OFF, NORMAL, HARD
LTI.
Adjusts the clearness of the outlines of the luminance
signal.
Setting value: OFF, NORMAL, HARD
COLOR SYSTEM
Selects the color system.
Setting value: AUTO, NTSC, PAL
NOTE:
• If the picture is unstable with “AUTO,” select “NTSC” or “PAL.”
COMPO. LEVEL
Sets the level of the component input signal.
Setting value: SMPTE (for M2VTR signals),
BETACAM (for BetacamVTR 0% set-up signals)
ADJ. BAR POSI.
Selects the position of the adjustment bars.
Setting value: UPPER, LOWER
all reset
Restores all the settings and adjustments of the
monitor to the factory settings.
• Adjustments made by using the buttons on the
front panel will also be reset.
NOTE:
• “HOUR METER X100h” (☞ page 17) will not be reset.
• After performing “all reset,” the screen goes back to the
MAIN MENU.
1 Select “all
reset”
Perform “all reset”
Cancel
NOTE:
• The menu automatically disappears in about 30 seconds after the last menu operation.
• Some items may not appear on the menu. Those items are not available for the current input or the current input signal.
2 Next
1 Select
2 Adjust
MAIN MENU
7 To exit the menu:
03_TM-15L1D-EN2.indd 1403_TM-15L1D-EN2.indd 14 06.11.15 1:07:37 PM06.11.15 1:07:37 PM