Operating instructions

24
Installation and Connection
4.Inserting the silica gel supplied
Take out the silica gel from the aluminum
package, insert it into the silica gel insertion
space of the camera unit and fasten using the
lug plate.
Memo:
● During reconnection or re-installation after
repair or maintenance, make sure to replace
the silica gel with a new one.
● Consult your nearby JVC’s dealer on the
replacement procedures.
Serial number of part to be replaced: Use a
LW40500-001A silica gel.
Note:
● When mounting is performed on a rainy day,
make sure that rain water does not enter this
unit.
● Make sure to use the silica gel supplied.
Failure to do so may cause the camera lens
and dome cover to fog.
● If the angle of view is not adjusted
immediately after mounting the camera,
insert the silica gel after adjustment is
completed. The silica gel loses its effect if it is
exposed to the air for a prolonged period of
time.
Mounting the camera unit
(continued)
Silica Gel Insertion
Space
Silica Gel
Lug Plate
*TK-C215VP4 is used in the above illustration
TK-C215VP4_JP.book Page 24 Thursday, November 2, 2006 10:51 AM