Manual

-O
_Ni_ii{iiii!iiiiiiiiiiiiiiilXili!iiiiii
• The test tone comes out of the speakers in the following order:
Left front speaker J, Center speaker
Subw!ofer
Right fron_speaker
Left rear speaker = Right rear speaker
There is a time limit in doing the following steps. If the setting is
canceled before you finish, press SOUND and start from step 4
again.
4
Adjust the speaker output
levels (-6 dB to +6 dB).
Adjust the center speaker, rear
speakers and subwoofer levels
comparing to the sound from the
front speakers.
• To adjust the center speaker level, press CENTER +/-.
• To adjust the left rear speaker level, press REAR-L +/-.
• To adjust the right rear speaker level, press REAR-R +/-.
• To adjust the subwoofer level, press SUBWOOFER +/-.
,5 Press STOP to stop the test tone.
6 Press SOUND again.
"SOUND OFF" appears on the display.
You can adjust the following settings.
It is recommended that you make adjustments from your actual
listening point.
- Output level for the center speaker
- Output level for the rear speakers
- Output level for the subwoofer
I Load a disc, and Press STOP.
The source changes to DVD and playback stops.
2 Press SOUND.
"SOUND" appears on the display and the 10 keys
are activated for sound adjustments.
Notes:
• Ifa disc is no loaded, you cannot adjust the settings.
• You can adjust the speaker output levels without outputting the test
tone.
• If there is a speaker from which no sounds comes out, check the
speaker's connection (see pages 6 and 7) and setting (see pages
53 and 54).
• If you press SETTING while adjusting sound, speaker settings
altemate between 5. l ch (use all sattelite speakers and subwoofer)
and 2. lch (use only front speakers and subwoofer.)
• You can output the test tone in any surround mode, or even when
surround mode is not activated.
• When an MP3 disc is loaded, you cannot adjust the subwoofer
output level.
3 Press TEST to check if you can hear the
sounds through all the speakers at the
equal level.
Test tone menu appears on the T*
23