Operation Manual

44
Playing back sources from other devices
1 Press [LINE].
• Each time you press [LINE], the display
changes in the display window as follows.
- “LINE 1” for selecting the device con-
nected to the [LINE IN 1] terminal
- “LINE 2” for selecting the device con-
nected to the [LINE IN 2] terminals
- “TV SOUND” for selecting the TV con-
nected to the [AV] terminal
- “LINE-DIGITAL” for selecting the digital
audio device connected to the [LINE-DIGI-
TAL IN] terminal
• You can also select the connected device as
the source by repeatedly pressing
[SOURCE] on the main unit.
2 Start playback on the connected
device.
• Refer also to the operation manual for the
connected device.
3 Adjust the volume and make other
necessary settings.
• Refer to “Basic operations” on page 17.
You can select the gain of the signal from the
[LINE IN 1] and [LINE IN 2] terminals.
Use the initial settings for normal operation. If the
sound is too small or too loud, change the settings.
1 Press [LINE] repeatedly to select
“LINE 1” or “LINE 2” in the display
window.
2 Hold down [ENTER].
• Each time you hold down [ENTER], the dis-
play changes as follows.
“LEVEL 1” : the initial setting for “LINE 2”
“LEVEL 2”
“LEVEL 3” : the initial setting for “LINE 1”
• The signal gain increases in the order of
“LEVEL 1”, “LEVEL 2” and “LEVEL 3”.
NOTE
• You can select the signal gain respectively for
“LINE 1” and “LINE 2”.
Selecting other devices as the
source
Selecting the signal gain
Playing back sources from other devices
DD-831[B].book Page 44 Thursday, August 24, 2006 12:05 PM