Manual

• Rein" terminals of RX-8030VBK are used for explanation.
Front speakers 1 Front speakers 2
Right / Left Right / Left
Surround back speakers*
Right / Left
RIGHT LEFT
SURROUND_Q( SPEAKERS•
Center speaker
_TER
FRONT SPEAKERS
SINGLE USE
Manual For
Connection
* When using only one
surround back speaker,
connect the (_ cord to the
RIGHT _ terminal and the
cord to the LEFT _
terminal
LKERtMPEDA
I//1-_\\1
I\\v//I
RIGHT LEFT
SURROUNDBACKSPEAKERS,
Surround speakers
Right / Left
IMPORTANT:
After connecting tile speakers, set the speaker installation
information properly. You can use Quick Speaker Setup for
easy speaker installation information setting (see page 25).
• "Ib obtain the best possible Surround/DSP effect, see "Setting
the Speakers" on page 27.
Connecting the subwoofer speaker
You can enhance the b_s by connecting a subwoofeE
Connect the input jack of a powered subwoofer Io the rear panel, using a cable with RCA
pin plugs (not supplied).
RX-8030VBK RX-7030VBK
RX-7032VSL
PREOUT SUB_ _FER
[ _f_ SUSWOOFER
Placing speakers
Front speakers and center speaker
• Place these speakers (position of the mid-range speaker units) al the same
height from the floor.
• Point these speakers aiming al the listener's ears.
Surround and surround back speakers
• Place these speakers at a position which is 1 meter higher than the lislener's
ears.
• Point these speakers down aiming al the lislener's ears.
Subwoofer
• You can place it wherever you like since bass sound is non-directional.
Normally place it in front of you.
Note:
Ideal speaker layout requires that all speakers be placed at the same distance
from the llstene_ However, since in some places it may be difficult to fulfil this
requirement, this unit can adjust the delay time so that the sounds through all the
speakers reach the listener with the same timing. (See page 28.)
10
Subwoofer
*When one surround back speakeris
connected.