Manual

AM Antenna Connections
Turn the loop until you have the
best reception.
Snap the tabs on the loop into the slols
of 1he base to assemble the AM loop.
3
Notes:
• If the AM loop antenna wire is covered with vinyl, remove
the vinyl by twisting it as illustrated,
• Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord. This
could cause poor reception,
• ff reception is poor, connect an outdoor single vinyl-covered wire
(not supplied) to the AM EXT terminal (Keep the AM loop antenna
connected,)
You can connect the following speakers:
• Two pairs of front speakers to produce normal s_ereo sound.
• One pair of surround speakers to enjoy the sun'ound effect.
• One sun'ound back speaker or one pair of surround back speakers
to enjoy to produce more effective surround effect.
• One ccnler speaker to emphasize human voices.
• One subwoofer to enhance the bass.
CAUTION:
Use only the speakers of the SPEAKER IMPEDANCE indicated by
the speaker terminals.
• When connecting to both of the FRONT SPEAKERS _1 and _2_
terminals, use speakers with an impedance of 16 _ to 32 _.
• When connecting to either the FRONT SPEAKERS _1 or _z_
terminals, use speakers with an impedance of 8 _ to 16 _.
Basic connecting procedure
1 Twist and remove the insulation at
the end of each speaker signal cable
(not supplied).
2 Open the speaker terminal.
RX-7030VBK/RX-7032VSL
(For FRONT SPEAKERS 2 terminals)
3 Insert the speaker signal cable.
4 Close the speaker terminal.
For each speaker (excepl for a subwoofer), connect the (+) and
(-) lerminals on the rear panel to the (+) and (-) terminals
marked on the speakers.
Speaker laveut
Ideal speaker layout varies depending on 1he conditions of your
lislening room. The diagram below is a recommended typical
example.
Subwoofer
Left front speaker(s) Center speaker Right front speaker(s)
(L) (C) (R)
Left surround Right surround
speaker (LS) speaker (RS)
Surround back speakers (LSB/RSB)
9