Operation Manual
9
Preparation
NOTE
• When you want to listen to sound from a TV,
connect the TV to the [AV] terminal as well as
the [COMPONENT] terminals.
■ IMPORTANT
• Connect the main unit directly to a TV (or a mon-
itor) without routing through a video cassette
recorder (VCR). Otherwise picture distortion
may occur during playback. (Routing the con-
nection through a VCR, however, does not affect
the audio quality.)
• Connecting the main unit to a VCR-built-in-TV
may also cause picture distortion during play-
back.
This system can output uncompressed digital
video signals to a TV compatible with HDMI (High
Definition Multimedia Interface).
NOTE
• The HDMI video signal type can be checked with
the “HDMI” indicator in the display window.
(Refer to “Selecting the video signal type” on
page 11.)
• If the picture is distorted while an HDMI TV is
connected, turn off the main unit and turn it on
again.
• A TV compatible with HDCP (High-Bandwidth
Digital Content Protection) can also be con-
nected to the [HDMI MONITOR OUT] terminal,
so that the uncompressed HD video signal type
can be output as well.
• This system is compatible with some basic func-
tions of HDMI CEC. (Refer to page 55.)
• When you want to listen to sound from a TV,
connect the TV to the [AV] terminal as well as
the [HDMI MONITOR OUT] terminal.
Connecting a TV with the
[COMPONENT] terminals
Main unit
(rear view)
TV
To component
input terminals
Component video cable (not supplied)
Main unit
Direct connection
TV (or monitor)VCR
Connecting a TV with the [HDMI
MONITOR OUT] terminal
Main unit
(rear view)
To an HDMI input terminal
HDMI cable (not supplied)
TV
Preparation (continued) Do not connect the power cable until all other connections have been made.
NX-F3_NX-F7[B]-03.fm Page 9 Friday, March 21, 2008 2:27 PM