Micro Component System Instructions

DAB antenna

For the better DAB reception

• See also “To improve DAB reception” on page 15.

AM/FM antenna

To assemble the AM loop antenna

To connect the AM loop antenna

• If the AM loop antenna wire is covered with vinyl, remove

the vinyl to expose the tip of the antenna by twisting the

vinyl.

For the better AM/FM reception

• Disconnect the supplied FM antenna, and connect to an

outdoor FM antenna using a 75

Ω

wire with coaxial type

connector (IEC or DIN45325).

• Make sure the antenna conductors do not touch any other

terminals, connecting cords, or the power cord. Also, keep

the antennas away from metallic parts of the System,

connecting cords, and the AC power cord. This could cause

poor reception.

DAB antenna (supplied)

Extend the wire so that you can

receive your desired ensembles.

Active antenna

(not supplied)

FM antenna (supplied)

Extend it so that you can

obtain the best reception.

AM loop antenna (supplied)

Turn it until the best reception is

obtained.

AM loop antenna (supplied)

Keep it connected.

Outdoor FM antenna

(not supplied)

Vinyl-covered wire (not supplied)

Extend it horizontally.

UX_GB9.book Page 4 Thursday, May 18, 2006 4:18 PM