Micro Component System Instructions

16
Changing the Display Mode
While listening to a DAB service...
* Non DAB signal.
Searching for a Service by PTY Codes
You can locate a particular kind of program from among all
the services you can receive by specifying PTY codes.
1
While listening to a DAB service...
2
Select a PTY code.
3
Start searching.
The receiver searches all the available ensembles, stops
when it finds a program of the selected PTY code, and
switches to that service.
• If no program is found, “NOTFOUND” appears on the
display.
• To stop searching any time during search, press
CANCEL.
To continue searching after it stops on an unwanted
service
While the PTY code is flashing on the display for 10
seconds, press PTY SEARCH again.
Service
label
“NOSIGNAL” will appear if no signal is
sent.
PTY The broadcast program type is displayed.
“NONE” will appear if no signal is sent.
DLS Dynamic Label Segment (text messages
the station sends) is displayed.
“NO TEXT” will appear if no signal is
sent.
Remote
ONLY
DISPLAY
MODE
PTY
DLS
Service label
Frequency
Ensemble ID
Clock*
Preset channel
number
Remote
ONLY
PTY SEARCH
QP Link
S.TURBO
BAND
QP Link
S.TURBO
BAND
DOWN
PRESET/GROUP/PTY
UP
• For details about each PTY code,
see page 17.
PTY SEARCH
QP Link
S.TURBO
BAND
QP Link
S.TURBO
BAND
Ex. When “NEWS” is selected
PTY SEARCH
UX_GB9.book Page 16 Thursday, May 18, 2006 4:18 PM