OperationManual

29
Menu Functions
POWER MANAGEMENT menu
Warping
This function aims at correcting the geometric distortion of the projector’s
images when they are projected onto an uneven surface such as a cylinder, a
spherical shape, etc.
• Enable
When this function is enabled, the following functions will not be available:
Keystone, Corner Adj..
• Control Method
Allows you to select a preferred control method for warping adjustment.
• Warping Adj.
This function is available when On is selected in the Warping > Enable menu
and OSD is selected in the Warping > Control Method menu.
1. Use / / / to move the cursor to the point you wish to adjust.
2. Press OK to enter adjustment mode.
3. Use / / / to shift the point by x and y coordinates.
4. Press MENU to exit adjustment mode.
5. Repeat step 1 to 4 to adjust another point until you are satisfied with the
projected image.
6. Press MENU to exit the function.
• Reset
Returns settings in the Warping menu to the factory preset values.
Zoom
Zoom your lens between 0.8X ~ 2.0X. The default is 1.0 X.
Digital Zoom
Digitally zoom the vertical/horizontal focus from -50 to 50.
The function is not available when Zoom is 1.0X or higher.
Submenu Functions and Descriptions
Auto Power On
• Signal
When Signal is set to HDMI, projector will auto power up from standby mode
when HDMI signal is plugged into projector.
• Direct Power On
Allows the projector to turn on automatically once the power is fed through the
power cord.
Power Settings
• Auto Power Off
Prevents unnecessary projection when no signal is detected for a long time.
See "Setting Auto Power Off" for details.
• Sleep Timer
Set the timer to turn off the projector. A confirmation message will pop up to
confirm turning off the projector when the timer counts down to zero.
• Power Saving
Light source will enter low energy mode if there is no signal for 5 minutes.
Submenu Functions and Descriptions