Operation Manual

English - 10 -
Using Side AV Connectors
You can connect a range of optional equipment
to your LCD TV. Possible connections are shown
below. Note that cables shown in the illustration are
not supplied.
• For connecting a camcorder, connect to the VIDEO
IN socket and the AUDIO SOCKETS. For selecting
the related source, see the section “Input selection”
in the following parts.
• To listen the TV sound from headphones, connect
to the HEADPHONE jack of theTV
Headphone
Connecting Other Equipment
via SCART
Most devices support SCART connection. You can
connect a; DVD recorder, a VCR or a decoder to
your LCD TV by using the SCART socket. Note that
cables shown in the illustration are not supplied.
Power off both the TV and the devices before making
any connections.
For more information, refer to your device’s own
instruction book.
Note: S-VHS VCR should be connected to EXT-1 and can
be watched from EXT-1S source.
Scart socket
Decoder
DVD Recorder
Video Recorder
Switching the TV On/Off
To Switch the TV On
• Connect the power cord to the 220-240V AC 50
Hz.
• Switch the “
” button to position “|” so the TV will
switch to standby mode.
• To switch on the TV from standby mode either:
• Press the “
” button, / or a numeric button
on the remote control.
• Press the
or button on the TV.
The TV will then switch on and the standby LED
lights up.
Note : If you switch on your TV via PROGRAMME UP/DOWN
buttons on the remote control or on the TV set, the programme
that you were watching last will be reselected.
By either method the TV will switch on and the standby
LED lights up.
To Switch the TV Off
• Switch the “ ” button to position 2 as illustrated,
(
) so the TV will switch OFF.
• To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode, standby LED
can blink to indicate that features such as Standby Search,
Over Air Download or Timer is active.
Input Selection
Once you have connected external systems to your TV,
you can switch to different input sources.
• Press “AV” button on your remote control for directly
changing sources.
or
• Select “Source” option from the main menu by
using “
” or “ ” button. Use then “ ” or
“ ” button to highlight an input and press “ ” button
to select.
Note: You can mark desired source options by pressing the OK
button. Therefore, when
“AV” button is pressed, only the marked
source options will be available (except for the TV source).
A01_[GB]_MB45M_26741W_(RM-C2503-1C_UK)_IDTV_NICKEL13_10067199_50162791.indd 10A01_[GB]_MB45M_26741W_(RM-C2503-1C_UK)_IDTV_NICKEL13_10067199_50162791.indd 10 08.04.2010 08:47:3208.04.2010 08:47:32