Operation Manual

Appendix

Bikeholder

You can attach your navigation system to a bicycle as an op-

tional additional feature. A special holder is needed to do this.

The installation is explained in the following.

1. Release both the screws

connecting the clamp to the

holding plate with the

hexagon key.

2. Remove the rubber ring and

wind it around the

handlebars.

3. Position the clamp on your

bicycle handlebars, by

pulling it across the

handlebars from below.

4. Put the holding plate back onto the clamp and retighten

both the screws.

5. Seat the holder for the navigation system on the holder

plate until it locks into place audibly. Please pay attention to

the fact that the holder must only be seated in one direction.

6. Now place the device on the holder. You must pay attention

to firm positioning.

Your navigation system could also be equipped with a different

bicycle mounting, where the attachment of mountings can vary

slightly, according to the version.

Holding plate

Hexagon key

Clamp