Operation Manual

English

V. Starting the navigation software

Note: The memory card must always be inserted in

the device while the navigation system is being used.

It will be necessary to carry out a Soft Reset to re-

start the navigation system if the memory card has

been removed, only for a short time, while the sys-

tem was being used (see page 23). This Reset will

take place automatically, according to the navigation

system.

1. Switch on your navigation system.

2. The Navigation software will start automatically or after

tapping on the navigation control button on the main

screen, according to the version.

3. Tap on Navigation on the screen for entering the destina-

tion and enter the address of your navigation destination.

Confirm your entry by clicking the

9 symbol to start the

navigation. You will receive the route information on the

screen, augmented by language statements, after a short

time, if the satellite reception is adequate.

Further information regarding the navigation software can be

found in the comprehensive manual on your navigation

CD(s)/DVD(s). This is a pdf-file you can read and print with the

any Acrobat Reader.

Note: The GPS-receiver will require some minutes

for initialization when deployed for the first time.

Even when GPS signal reception is indicated the

navigation could be imprecise. In all future instances

it will take about 30-60 seconds until a correct GPS-

signal is available, sufficient “sight” of the satellite is a

prerequisite.